Function knob twist does not midi learn

i have activated midi cc direct…

but ot is not listening…

help!

Hi, you have to make sure that the 2 machines are communicating on the same midi channel, afterwards it should work fine,
its worked fine for me anyway with a Nord Elecro and a Korg, not so good <ith the MPC cos alot of its parameters dont output midi code…

ok, so its normal that i dont get the message that ot is listening?

It sounds like you’re confusing CC direct connect with MIDI learning. first, make sure you have the track activated with the correct channel set like Rael said. then go to one of the ctrl setup pages, hold function, and press the knob you want to set the CC on. the ‘listening for MIDI…’ box should pop up at that point.

thanks all!

But, when using the same midi channel on voyager and ot, i get all kinds of midi loop problems, anyone else experiencing this?

I guess that is expected as im sending midi in aloop to and from voyager…

no experience with a voyager, but check for a local control off setting. then the keyboard for example should send to the OT and receive it back from the OT MIDI out without the keyboard also triggering note on/off internally.

its a rack voyager,

ok so everything local shoul be off.