I’m sure there’s some obvious control / shortcut I’m missing, but how do I fine tune parameter changes. There are so many ways to change it by a lot at a time (Function + or pushing the knob down), but I can’t figure out / find in the manual where I can change it by a very small mount.
For instance, I’d like to change the pitch of a sample by less than .2 semitones at a time.
Thanks.
i’m unaware of finer control, but i’d hope that lfo modulations would interpolate, perhaps offering finer control potential, not ideal, but handy in a crisis where you may want to retune - just use a low depth setting on a custom lfo with a flat shallow offset and tune to taste
The internal resolution of many parameters is finer than what the knob control permits. It can be heared with LFOs, Scenes, and P-lock slides.
Two ways to access it.
-
scenes
If you want to get between two integer parameters, scene lock consecutive values and use the crossfader. Quick and easy. Useful for resampling.
-
If you need to save the “in-between” value with the pattern, a static LFO is the way to go. Use the designer, and create a non-zero horizontal line.
1 Like
Just wanted to pop in LITERALLY 10 YEARS LATER to tell you that this technique cracked a major problem for me tonight. Thank you!
2 Likes
1 value on lfo designer, speed 0 is faster to setup. Trig mode
2024 technique. 
3 Likes
hahah the field continues to advance
I used the LFO designer trick above but created a straight line all the way across rather than using a single value and 0 speed + trig mode. Great tip. Thanks!
