I’m encountering an issue with my Analog Rytm using the bass tom pad during the first minutes after having powered on (check the audio sample attached)
This seems disappear while the AR is warming-up.
The issue seems to be cleared after two minutes of use.
When i reboot the AR just after having the issue, it does it again but much less : normal situation recovered just 20 seconds after having powered on the AR.
Note that when the issue is running, the BT pad is highlighted and it decreases as same as the “feedback” decreases too.
Is anyone experienced this issue before or could tell me if i ran an hardware issue or is it just a user mistake ?
Unfortunately, reducing the decay on the amp didn’t solve my problem…
Another point is that the issue not happens when i power on the AR with a pack bought on the Elektron shop (i.e. “reshaped pack”).
It seems the issue runs only with personal project…
is the sequencer running or are you hitting the pad?
i would check there’re no trigs on the sequence, just in case and then would probably head to the amp section and check in the trig section the LEN parameter (is it set to INF?)
