1

Hi, my new AK just arrived :slight_smile:

I noticed a problem with the encoders: The movement behavior of the encoders is different in the context of the parameters i want to tweak.

Curious :frowning:

For example: The 2 encoder knobs for FREQ (in the filter menu) are very very slow increasing/decreasing the FREQ parameter, if i move very slow and gently the knobs. But if i change the menu (for example to the parameters of OSC1) and move the knobs as slow as before in the filter menu, the changes of the parameters become normal speed.

I don´t mean the “normal behavior” and the “speed-behavior” (pushing knobs = full speed changing of parameters).

Anyone have this problem? Are my encoders damaged?

Thanks.

2

Sounds very normal. Switch to perf page all adjustable values are the same, every enc will be identical, if not then investigate!

3

Hmmm …

Is this right: Moving the FREQ knob in filter menu decreases/increases the parameter values more slower than moving the next knob (RESO)?

I mean: In the filter menu 1/2 slow rotation at knob 1 (FREQ) takes me to the value +30 and the same 1/2 slow rotation at knob 2 (RESO) takes me to the value +60.

This is normal ???

Pfffffffffftttt …

4

Yes, different parameters require a different resolution each to dial in values over a meaningful range. That’s very common with encoder-equipped gear. An encoder is not a potentiometer.

Anyway, here’s a hint. While turning the encoders press them down. You’ll now be able to sweep through a greater range of values with shorter travel.

5

some encoders cover 14bit range (16k+ values), some cover 1bit range(on off)

i think your expectation is broken :wink:

6

they are waaaaaaaaay too fidgety for quick precise usage, that much is true, the elektron nano-twist is an art form in itself !

7

thanks for your support !