Effects Blocks on Audio Tracks

buzz · 2015-03-21T10:52:39.000Z

hi
just to make sure I’m not missing anything here, but I am right in saying you can only have two effects active at the same time on a single audio track (or master) ?
thx

kippertoffee · 2015-03-21T11:04:52.000Z

Yep, two fx blocks per channel. A filter takes up one fx block. You can sacrifice channel8 to act as a master fx channel

sicijk · 2015-03-21T12:16:02.000Z

Yes, on a single Track.

But on a source (THRU-STATIC-FLEX) you can achieve 8 Fxs, using NEIGHBOR machines in series.

buzz · 2015-03-21T22:33:16.000Z

cheers

analogback · 2015-03-22T02:23:30.000Z

""sicijk"":

Yes, on a single Track.

But on a source (THRU-STATIC-FLEX) you can achieve 8 Fxs, using NEIGHBOR machines in series.

i don’t think you can use neighbour on all 8, just in blocks of 1-4 & 5-8… right?

GovernorSilver · 2015-03-22T19:26:36.000Z

""analogback"":

[quote=“sicijk”]Yes, on a single Track.

But on a source (THRU-STATIC-FLEX) you can achieve 8 Fxs, using NEIGHBOR machines in series.

i don’t think you can use neighbour on all 8, just in blocks of 1-4 & 5-8… right? [/quote]
I think you can use a Neighbor on any track except 8. The first track in the chain of course must not be a Neighbor.

rikrak · 2015-03-22T20:19:27.000Z

""analogback"":

[quote=“sicijk”]Yes, on a single Track.

But on a source (THRU-STATIC-FLEX) you can achieve 8 Fxs, using NEIGHBOR machines in series.

i don’t think you can use neighbour on all 8, just in blocks of 1-4 & 5-8… right? [/quote]
Right. I think sicijk is saying 2 FXs per Track, On either 1,2,3,4 or 5,6,7,8 would equal 8 FXs in total.

miketheman · 2015-03-23T09:23:52.000Z

As per manual:

Neighbour machines cannot be assigned to track 1 or 5.

So an thru machine on track 1 + 3 neighbour tracks. Same for track 5 (with 3 neighbour tracks). So yes, you could say 8 effect tracks (2 x 4 in series) in total (with their own LFO and sequencer possibilities), yielding 16 effects. But remember: Thru machines need to be trigged in the sequencer.

With the restrictions of when doing things in realtime (as in a live situation). Creative use of the track machines in different ways, means you can record and ‘write’ some of the effects into the sample (including parameters tied to the fader). And then make those neighbour track free again for sample playback of just those recorded samples (where you then can set LFO´s on top of that ‘written’ stuff).

An toolbox with different tools for different purposes…

Depending on what end-result you´re aiming for, skillfull use of parts (which allow different effects per part) and pattern changes (chains) might even extend it a bit further. Same goes for the Arranger (think pattern lenght, repeats etc)…