If the knot allows bias selection type A/B cables should both be fine.
I’m looking at this thread below which I copied from and checking out your manual for the po16. See if anything in the thread or the grid documentation linked here is useful for identifying any differences between your set up and the one described.
"
d4ydream
It’s pretty straight forward once you look through some of the Grid documentation:
Grid: Getting started | Intech Studio Documentation
Choose one of the guides below!
I’ve done custom stuff for Digitone and Loopy Pro. I have 2x EF44, and EN16 and a PO16. I can post some code and instructions if you have an idea of what you’re looking to do.
It’s getting late here though and I’m super bagged from spin. Car’s in the shop tomorrow so I’m working from home. Give me an idea about what you’re looking for and I’ll see if I have time to script something up."
So just because it’s for the octatrack, don’t try and copy the settings shown, but you should be able to use it to see what they were doing. Looks like it requires a software editor, is that not the case for po16?
Adding: Ok well their site says with a standalone host you should be good to go. Here’s some troubleshooting from the knot guide, what is the status of the led lights?
