Digitakt Polysynth sequenced by L11 piano roll

[xox]

I’ve been using the Retrokits RK002 cable with a Keystep 37 turning theDigitakt into an 8 voice polysynth when you load a single cycle waveform into each Audio track

Is it possible to send midi notes from the Ableton piano roll to the Digitakt to play a chord progression on loop allowing to manipulate the Digitakt parameters as you record the audio into Ableton to one track or multiple tracks?

I’m stuck after trying a few different methods and would really appreciate some input! Thanks

[garf]

Check out Polymind. Some info here…

Polyphonic Digitakt via Retrokits RK-002 cable?

I wondered the same thing – found this: http://www.maxforlive.com/library/device/2192/polymind There’s a bit of setup needed but it’s worth it: In Live’s midi prefs, make sure Digitakt midi out is enabled (using DT’s midi over usb). Add 9 midi tracks to a new Live project. Add the ‘Brain’ device to the first track, followed by the 8 ‘Satellite’ midi receiver-sender devices which will send the midi to the DT. Add the Satellite 1 device to track 2, Satellite 2 device to track 3, etc. Basicall…