Hi, yesterday i was playing with my digitakt 2 and everything was normal, i turned it off normally and today i started it and surprise! Everything is gone, like a total reboot, even the presets disappeared without trace, how can something like that happened, i abandoned the octatrack because i wss tired of losing everything once in a while, is it the same with the digitakt? What a shame and how infuriating to lose a month of work. Does anyone have had the same experience?
1 Like
No. Nor with Octatrack.
Did you change / save project ?
Did you use orginal Preset Project ? (Locked)
Sorry for your loss. Have you tried running the device self tests.?
Maybe you have to wait for all samples to be loaded. My dt2 didn’t contain the audio samples I recorded into it. It took 1 minute, then everything was there
1 Like
Hi, no, I didn’t do anything, i saved the project probably 10 min before turning it off, and yeah, it was the original project.
1 Like
Not yet, but i will try! Thanks!
I waited for a bit but nothing came, not even the steps or anything, and not even the assigned samples.
1 Like
So you are saying you saved the preset project?, did you save it to a new slot?, as if not it probably cant be saved as it is locked.
1 Like
Can be something like that, the weird thing is that all the initial patterns also disappeared and all the steps.
I have had similar problems several times and I also can’t find a solution.
After saving the project and rebooting the synthesizer, I get such problems
1/sometimes the sound of the first Kick trigger just becomes very quiet and I can’t change its volume settings - it’s still quiet. There are no problems with velocity. There are no problems with the compressor. Sometimes this problem disappears after rebooting - sometimes it doesn’t.
2/ More and more often I notice that the triggers change places after rebooting the synthesizer. I add a sample to trigger number 3 (can see on my photo)
, and it shows that it is installed on trigger number 10
3/ sometimes all the drawings just disappear, but the sounds of samples remain in place.
I have a new firmware and still these problems often interfere with normal operation
I will be glad to receive any suggestions on how to fix this.
Did you use the original power adapter or something other like a battery?
Did you turn it on and off and on again within a short time?
1 Like
Did you actually load the project manually or just used the „autosave“ the Digitakt loaded by itself on startup?
I had an issue like this with my Syntakt and that seemed to be the solution.
2 Likes
Loading a sample into slotA10 doesn’t doesn’t mean it’s on button 10. There’s not direct link to slot and pad … it’s entirely up to you how the sample it assigned and triggered.
Your image is showing a sample loaded into sample slot A10 .
But … it shouldn’t move around between saving / reloading.
3 Likes