surprised too … it’s always been pretty straightforward imho, but i’ll try to help.
first, to get the obvious out of the way: when you check the arp page, the arp is NOT off, correct?
…anyway, the basics:
[ol]
[li]clear your kit, clear your pattern, start with a blank slate 1-bar pattern. [/li]
[li]load a synth into T1.[/li]
[li]set up an arp with all default settings, EXCEPT in SID mode so it runs continuously. all green steps in the arp itself.[/li]
[li]in the mnm’s main sequencer, place a single regular trig on the first step.[/li]
[li]hold the trig button down and hit the down arrow so a blank space for a second note appears in the display. [/li]
[li]while still holding the trig, now use the right arrow to make that blank space indicate +2 (or something other than blank)[/li]
[li]hit play and you should hear the synth’s arp play back and forth between the 2 notes. [/li]
[/ol]
2 Likes