You can do it on Rytm but struggle to find on OT. It wants to finish pattern.
If you mean direct jumping between patterns it can’t do it. I’m pretty sure in the settings you can change it to a minimum of 2 steps before a pattern change. Ive never tried it though so don’t take that as gospel
2 Likes
OT has a project setting for Chain After in the main menus under Sequencer…
This can be overrided per pattern by entering the pattern settings (func+bank while not in grid rec), unchecking use project setting, and then entering a value for use pattern setting, goes down to two steps like @jb said…
Don’t know if you run at x2 scale if those 2 16th steps will turn into 2 32nd steps…
1 Like
Ok cool. Thx
1 Like
Oh, but I think your going to find it’s more like direct start than direct jump…
The OT can do direct jump from the Arranger using its OF and LN parameters, it will change instantaneously mid pattern but you have to arrange it.
You can even sequence part changes within a pattern this way…
1 Like