Change pattern waits for one loop more

Elektron Gear Digitakt
1

Hello!

I’m new here. I’ve just bought a 2nd hand DT and did a factory reset. FW version is 1.11. The problem I have is when I queue next pattern it does not wait for the current one to reach it’s end but it waits for one (full) loop more. Furthermore, this behaviour is quite erratic, because in rare occasions it does go to the next pattern on the end of current one (the one a pattern change was pressed). Pattern value on the top-left of the display is blinking between old and new one in both cases. Is this a feature or a bug or is there a setting where I can choose to play next at the end of current?

EDIT: omg, I should RTFM! Page LEDs do not represent pattern length. This is kind of baffling, though…

Cheers!
p.

2

Hey welcome…
First i would recommend update to the latest firmware much better features and bug fixes…
It should work if you set the Master length (M.LEN) to the time you want it to change…
if you want to have a longer master length or set to inf length
and you want it to change earlier you need to set the Change length (CH. LEN)
and it should work but not sure about the firmware you are using

1 Like
3

Yes, you are right, thank you. I appologize for not reading the manual thoroughly and cluttering this forum with an unnecessary topic.

1 Like