Card status yellow after bank switching

Elektron Gear Octatrack
1

I sometimes have an issue that a card status is turning yellow/orange after a switching bank.
Yes, I use static machines but I always have a green led status if I use only one bank. :thinking:
1.25E

2

i believe that’s just a notification that changes you’ve made haven’t had a chance to sync to the memory. if you stop the sequencer for a few seconds the light should go back to that comforting green glow. if not, try forcing a sync to card under project settings.

2 Likes
3

You are right, thanks.

Quote from a manual:

Sometimes data cannot be written until [STOP] is pressed. The LED will then remain yellow until so happens.

2 Likes