My Syntakt on track 10 makes always a noise like bit reduction… Kicks sound I’m lowering sample rate … Can anyone tell me if anyone had this on the machine?
Thanks in advance
Which machine is on track 10? Or is the machine type irrelevant?
Did you try “INIT TRACK SOUND” for track 10?
In all of them
No I haven’t
do you only hear it via headphone ? or left/right outputs …
is it also via usb class compliant audio or overbridge.
basically check all the obvious outputs to narrow down if its hardware / usb / digital
and check if things are routed via fx track or directly out .
Make a sound on track 9, copy/paste it to track 10, do they sound the same?
(To copy a sound use TRK+COPY, to paste it use TRK+PASTE)
If they sound different then it’s probably a hardware problem.
(Tracks 9, 10, 11, 12 are analog tracks with separate circuits for each one)
It does on my all analogue sounds like track 9, 10 , 11 and 12
but strange when i load the ADRIANA proj from factory it doesnt to that crackin noise
Are you sure it’s not just volume clipping on the output?
Try turning down the track’s volume level.
(the knob just above the red button, not the main volume knob)
No it does on low levels too
It might also be because of FX block settings if it’s going through FX.
A sound recording and a project file would be worth a thousand words.
It’s not via the efx routing
I’m already in contact with support
Let’s see
Try recalibrating, maybe?
1 Like
Here is a video making cracking noise and also changing pitch and slow responding machine
This is super weird.
Do you have a MIDI loop or something like this?
No the machine is very slow responding
In French, the title is hilarious, just saying.
Why is it showing midi setup on screen?
Disconnect ALL cables except audio out.
It has no midi cables plugged I don’t even use midi , only usb cable but I’ll unplug that and check later today
I unplugged the usb cable and works fine
Plugged in again and all good
Thanks