Automatic Doubling Pattern length when pattern steps have been p

Elektron Gear Analog Rytm
1

Hello,

Sometimes I copy a pattern that has a scale setting of: 32/32 into a new pattern.

When in the new pattern, if i set the scale to 4/16 in the new pattern, then rescale it to 8/16 (or any other value) i end up getting the trigs that were in the 32/32 sequence and, not a copy of the first 4 trigs (as per manual page 39: “Trigs are automatically copied when extending the length of a pattern”) . I can see wanting the original trigs(especially if you’re on the same pattern), but i wish there was also a way get the other result.

I would think/hope there’s a way to ‘clear’ trigs beyond the current step settings so that when you extend the length, it creates a duplicate of the trigs.

Anyone have a solution to this ?

Thanks!

2

Not near a m/c to look further at your specifics, but the automatic extension applies to pages
Ie if you go from 16 to 32 the first page is duplicated to the second and so on

3

if someone finds the solution to this, please post it here!!
Looking for this function for a while, a simple command to double the pattern, in the way it happens when you press fn+page, but with odd measures.