I get this message when I try to auto sample from my Sequential Take 5, no matter what the patch is.
I’ve auto sampled several other synths fine. It makes no difference if I turn the master output down on the Take 5. Any idea what I’m doing wrong, or whether this is a bug?
What does it says when you press YES on first Auto Sampler page ?
That’s the exact message, “input signal…” etc when I press the first ‘yes’ to test.
I think if there was a way of adjusting the threshold, it could be sorted. The Take 5 seems to have some low level signal that is probably the issue (though it’s silent, there’s no audible hum etc).
Ok. Maybe TV detect some noise or dc offset…
And can you multi sample ?
Yes I can multisample, so it’s not critical, just a bit of an annoyance to see it every time, and not be able to do anything about it. I wanted to see if I was doing anything wrong.
A threshold control (like on recorder) would be a useful addition perhaps.
Sure ! Apparently issues with slow attack patches too.
And I’d also love a threshold to trigger recordings with non midi audio sources…