I have a problem with my AR
after saving a kit
reloading or selecting another pattern kit loses some settings .
It activated analog part on the pads where it was not active .
that is not stored as part of a kit - it is a track/pattern setting !
Thanks
but where I can change this setting ?
the lighter gray ‘Trig’ page button next to the ones associated with sounds/kit etc !
ok 
I knew
I deactivate the analog part (1 to 0) from trig menu and save the kit .
when reloading kit or change the pattern I find the analog part of some pad again changed .
(0 to 1 )
The settings in the Trig page are saved as part of the track / pattern, not the kit. Make the required changes, then save the track or pattern, as avantronica said.
Easy to test this by changing to the other pattn and reloading the kit (NO+FX). This is because the pattern data overrides the kit data IIRC… Or was it that “reload kit on patt chg” parameter in the config?