Dear Community, I got a problem with my reverb send. On Track 1 I have a sequence running which should not be reverbed. On Track 2 another sound is running that should be heavily reverbed. So my send-settings are:
Track 1: Chorus 63, Del 0, Rev 0
Track 2: Chorus 0, Del 47, Rev 127
FX/Chorus: Del 0, Rev 0
FX/Del: Rev 0
FX/Rev: Vol 100
no p-locks for FX Sends, no Aftetouch, Breath or Mod Wheel.
All Voices are on, Allocation is set on Reset, Trk Sound on.
BUT: Track 1 is heavily reverbed. WHY?? maybe I missed something? Or is it a bug?? I never had this before.
do you have overlapping notes on track 1, if you do, as you have use track sounds selected the track 1 seq will then elect to use sound 2 if the sequencer notes overlap
why do you have use track sounds ticked anyway ?
test the premise on a new simple pattern or look at the note lengths on the sequencer track
No FX is sent into the Reverb. The send is like hard wired just in this sound, I can just end it by de-routing the track into FX, but this is not my favourite solution.
Yes you are right, “use track sounds” is not necessary. I changed that, but the reverb is still there, and it doesn’t come from track 2. even if all tracks are muted but track 1, Reverb is on.
is it a performance macro or a conflict of midi origins (disconnect everything and check track channels)
save your project, load a new one and test on a blank pattern - I did as you described and the only way i could get reverb via track 1 sequencing was to have overlapping notes on that sequence
in other words it’s not an obvious candidate for a bug
if you can describe the least possible steps to replicate this from a new project then that can be investigated
