Hi everyone,
I have an A4mkII with 1.35B, and I noticed a weird thing.
In the pattern length screen (shift-page) I set it to “Adv” and adjusted the master LEN using the Track Level knob. I held FUNC so that it would move in nice increments.
I can increase the value of the Master LEN field while holding FUNC, but when I try to decrease it, it … keeps increasing. But the value flickers up and down; it goes more up than down, so the overall effect is of it going up. It’s as if the device is reading the anticlockwise turn ok, but overlaying clockwise turning.
If I don’t hold FUNC, I can increase and decrease the value as expected.
Using that same knob in other screens (like menus etc) is ok (also while holding FUNC.)
Has anyone else experienced this? If so, did you already open a bug report? If not, and if you can reproduce, I’ll open one.
Thank you in advance!