Analog four CV microbrute

Elektron Gear Analog Keys/Four
1

Hi everybody.
I configure my analog 4 to sequence my microbrute CV.
Large stereo jack in CV input AB to two mini jack mono plug in gate in and CV in pitch of the modulation matrix of the microbrute.
In the A4
CV A = pitch V / oct
CV B = gate -> level 3.0 V

the A4 sequences the microbrute, I hear the microbrute on the keys of the keyboard but I have the same note everywhere.
Do you know what I need to configure for each note on the A4 to be different?

2

assuming your cables and wiring are as you expected then just check you have a 1v/oct gradient on the pitch

so cX= Yvolts
c(Y+1) =(X+1)volts

e.g. c0 0v
c1 1v

swap a for b in case there’s a cable issue

if you want to test more methodically - stick with one Cv channel and vary the filter freq whilst you drone the arturia - then set the other CV channel , then set for pitch/gate etc

there’s a load of threads on this and as far as the microbrute goes it makes no difference as long as it’s a v/octave synth (some of the moogs seem to need a bit more effort though)

1 Like
3

I forgot to say that I just started to learn CV , so I don’t understand your message, sorry. Could you explain once again for a noob. And the LFO and envelop of the A4 have no effect on the microbrute

4

Best to read the threads, the manual has examples iirc and there are lots of YouTube videos too which will probably be simpler to follow

https://www.elektronauts.com/search?q=CV%20setup%20%23elektron-gear%3Aanalog-four

Youtube links

5

Thanks you :slight_smile: i’m going to look at this