A4 Changing Multiple Parameters at Once

Elektron Gear Analog Keys/Four
1

Hello all.

Been loving the A4 and this community. So much good information being shared here.

I have run into an issue or bug recently that I can’t seem to figure out. Hopefully it is nothing more than something user error related on my end.

When I am starting a new project and begin changing parameters (oscillators, filters etc…) if i turn one knob to lets say adjust the frequency of the filter. Followed by changing the resonance. When i touch the resonance knob, the filter frequency will change as I turn resonance up/down. Should more than one parameter be affected as I turn this knob? It happens no matter which track or parameter I am adjusting.

Could it be a setting I need to deactivate? I looked through the manual and seem to be missing something here.

2

Are you making the changes at the performance - level or at fiter - page level ?

3

Possible midi loop?

4

I am making the changes at the filter page level.

5

Hmm perhaps. I will dive a bit deeper and see where all of the midi is routed from hardware and DAW.

6

May be a case of changing (not at my ak so cant remember exact names/places) encoder destination from int+ext to int in the midi config pages - stops encoder wiggles sending midi unless in midi mode :slight_smile:

If its not that - eek, aint meant to do that :-/

7

The same happened to me - it seemed like a link between several faders, in my case the volume-faders in performance mode and the mute-TRIGS. Stopped with changing encoder destination from int+ex to int.
f.