Hi!
I find myself constantly pushing down the encoders on Machinedrum when changing parameters. It’s just not necessary to do very small adjustments most of the time and I’m afraid that it will wear out the encoders. Is there a way to invert the intial setting, so that making bigger adjustments will be normal and pushing down the encoder will enable the fine tuning mode?
1 Like
Same for me for all my Elektrons (MD / OT / A4)…
I thought about inverting too but the option doesn’t seem to exist.
Did you change knob resolution to 32 ?
Global > Control > MECH SETTINGS
This setting seems to match OT’s settings.
Isn’t it @dubathonic ?
1 Like
@sezare56 is correct – there is no way to invert them as you describe. the only option we have is the one the manual describes, i.e. changing the encoder resolution.
2 Likes
since the potentiometers of my Monomachine begun to show signs of wear, i use my M-Audio Axiom 25 as a controller now, just to prevent worse. all pages have been neatly mapped. by the use of an external controller, those small steps in parameter changes are history. parameter locks are still possible also via controller of course.
1 Like