DT DIY Protective Lid/ Foam template

hey there,
as i cannot really afford a plastic-cover for 50 bucks with my budget, i searched for cheap diy solutions and found this thread here

i will do a similar thing for my DT and created a template to know where to cut the foam, so that the encoders are sitting well in the end.
it’s far from perfect but accurate enough i guess. i decided to share it with you.
maybe somebody finds it useful as a good starting-point for where to cut the foam.

greets

Digitakt_Blueprint003.pdf (8.1 KB)

Thanks for this! Going to make one later (currently just cover it with an old shirt.

1 Like

The template didn’t fit on one page when I printed it for some reason, but I made do.

Turned out well, thanks! Just have to spruce it up with some stickers or something…

hi,
sorry for the hassle. guess the lines are too close to the edges of the paper. one should probably move the whole scetch to the middle before printing. didn’t do that, just scanned it.
i’m glad that it worked eitherway :slight_smile:
i finished my lid yesterday, too.

greets

1 Like